Stopcocks and water supply
Stopcock won't turn off — or there's no water
The stopcock is the one valve you need to work in an emergency. If it's seized, just spins or is leaking itself, you need it sorted before anything else can be fixed.
Do this now
- Try turning the stopcock clockwise firmly by hand. Don't use a long lever or hammer on it — old brass can snap.
- If it won't close, look for other valves: an isolating valve on the pipe feeding the leaking fitting, or a valve on the tank feed in the loft.
- In a block of flats, ask the porter or managing agent about a valve on the riser or communal supply.
- If you know where the outside stop tap is and have the key, it can stop the supply from the pavement.
- Open the cold taps to drain the pipes while you wait.
What's wrong with the stopcock?
Seized
The handle won't move. Common on stopcocks that haven't been turned in years, especially in hard-water London. Forcing it risks breaking the spindle.
Turns but doesn't stop the water
The handle turns but water keeps flowing. The washer (jumper) inside has worn or come loose, or the spindle has snapped internally.
Leaking from the stopcock
Water around the spindle (a gland leak) or from the joints either side. Often starts after the stopcock is finally turned.
Can't find it
Boxed in, under kitchen units, behind a bath panel or in a communal cupboard. It's worth finding now, before you need it.
How we fix it
- Isolate the supply further back. At the outside stop tap, a communal valve, or with a pipe freezing kit on the supply pipe.
- Repair or replace the stopcock. Re-packing the gland can stop a spindle leak; otherwise we fit a new stopcock or a quarter-turn valve that's easier to close in future.
- Restore and test. We turn the supply back on slowly and check it closes fully.
Many older London properties still have lead supply pipes. If yours does, we'll tell you — a lead pipe affects what kind of fitting can be used and whether a longer-term replacement is worth planning.
No water at all?
- Check whether the neighbours have water. If they don't, it's almost certainly a supply problem — check your water company's website or service updates. In most of London that's Thames Water.
- Check your stopcock hasn't been turned off, and that any isolating valves are open.
- If only the cold kitchen tap works but nothing else, the cold water tank in the loft may be empty — often a stuck float valve.
- In winter, a frozen pipe can cut the supply. Turn off the stopcock before it thaws in case it has split.
If neighbours have water and you don't, message us — the cause is inside your property and we can find it.
What it costs
Charges depend on the time of day. Overnight, the first hour is £220, then £75 per half hour. Parts are extra and agreed before they're fitted. See every time band.
Questions
Am I allowed to use the outside stop tap?
The outside stop tap is part of the water company's network, but householders can use it in an emergency if they have the right key and can reach it. If you're not sure or it's stiff, don't force it — tell us and we'll deal with it.
How often should I turn my stopcock?
Turning it off and on again once or twice a year helps stop it seizing. If it's stiff, don't force it — have it replaced before an emergency.
Also urgent
Other emergencies we deal with
Each page explains what to do straight away, what we check and what can usually be fixed on the night.
Burst pipe
Split pipes, failed joints and water you can't stop.
What to doWater through the ceiling
Drips, stains, a bulging ceiling or water from the flat above.
What to doBlocked or overflowing toilet
Your only WC is blocked, or it's rising when you flush.
What to doBlocked sink or waste
Kitchen sinks, basins, baths and showers that won't drain.
What to doLeaking radiator
Valves, joints and heating pipework leaking onto the floor.
What to doShower leaking below
Water showing in the room or flat underneath.
What to doCan't turn the water off?
Send us your postcode and a photo on WhatsApp, or call. If water is pouring and you can't stop it, call.